GRS733 Ignition Lock Cylinder w Key 2014 Chevrolet Equinox 2.4 22808302
How To Get Key Out Of Ignition Chevy Equinox - How To Get. Also problem can be in gear shifter release button hanging up to find which is cause the problem when key wont come out tap on gear sifter listen for click if not key cylinder is cause dont spray any lub in key cylinder it will only make it worse if you can remove key cylinder take care not loose small parts clean inspected key cylinder with key in and all tumbler line up check. If you suspect a low voltage battery or notice a repeated clicking when turning the key, recharge the battery to see if it is a low voltage problem.
So when i put the key in it did not turn on and the key stayed stuck. The battery is fully charged and have not. That is done by removing the steering column shroud and chisseling or drilling off the captive bolts which clasp the lock assembly to the column. Hold the brake pedal then press the “ engine start/stop “. Sometimes the steering wheel is placing pressure on the steering lock and key release mechanism, so try turning the steering wheel in any direction it can go while trying to release the key. If you are lucky it might suddenly pop out. A great method for removing a stuck key from the ignition is to push on the key cylinder with your left hand’s index finger while jiggling the car key with your other hand. Turn the key to the “off” position. Turn the key to the “on” position. Another simple solution that you can take advantage of if your key is stuck in the ignition and the car key won’t come out is to simply lubricate the car key.
If the key fob battery goes dead, place the key fob into the front center console cup holder. Hold the brake pedal then press the “ engine start/stop “. If you have a chevy equinox, your key may be stuck in the ignition. As a dead battery can cause a car key to get stuck in the ignition, recharging the battery will free the key. To better protect your chevrolet equinox key fob and extend its battery life, it may be a good idea to have a key fob cover or a case. Also problem can be in gear shifter release button hanging up to find which is cause the problem when key wont come out tap on gear sifter listen for click if not key cylinder is cause dont spray any lub in key cylinder it will only make it worse if you can remove key cylinder take care not loose small parts clean inspected key cylinder with key in and all tumbler line up check. With a previously learned master key, turn on the ignition, with the engine off. Jiggle the key forward to ignition position and back hundreds of times, while you are pressing the brake pedal. You have to replace the assembly if you can't pull the end of the key out. If you are lucky it might suddenly pop out. The key is not daamaged it has remote start and when i tried to remote start it, made a noise like it was going to start but it stopped.
